Self-driving Toycar

From Hackers & Designers
Revision as of 15:29, 19 February 2017 by Heerko (talk | contribs)

Soon you will find here a step by step guide towards a self-driving toycar!

self driving toycar

What is exactly we want the participants to learn in this workshop? Do we have learning goals? It is going to involve some electronics/hardware knowledge(voltages/currents, wiring, h-bridge, infrared sensor, ultrasonic), some arduino and some pseudo code maybe. I am just curious how deep we want to go into any of these topics...

Workshop manual

Deconstuct the car

  • Remove the screws on the bottom and remove the top.
  • Cut of all the wires going to the BCP, as close as possible to the PCB. (make sure the power switch keeps working and that it is off)

Connect the Motor driver

  • Connect the motors to driver/h-bridge.
    (Add diagram with pin names. Dependent of which driverboard we're going to use.)
  • Connect the cars' battery to the driver
  • Connect (solder) the driver ground to Arduino ground

Test > Sample code to test motors over serial connection.

Connect the line sensor

Connect the line sensor analogue output to A0. GND -> GND VCC -> 5V

Stuff that might need explaining?

  • What is an h-bridge?
Retrieved from "https://wiki.hackersanddesigners.nl//index.php?title=Self-driving_Toycar&oldid=20540"